# JointCam
**URL:** https://forum.onefinitycnc.com/c/cad-design-software/jointcam/148.md
[Latest](https://forum.onefinitycnc.com/latest.md) · [Categories](https://forum.onefinitycnc.com/categories.md)
---
## [About the JointCam category](https://forum.onefinitycnc.com/t/about-the-jointcam-category/17565)
**Author:** [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\
**Replies:** 0
---
## [JointCAM Configuration](https://forum.onefinitycnc.com/t/jointcam-configuration/19033)
**Author:** [@JointCAM\_Gerry](https://forum.onefinitycnc.com/u/JointCAM_Gerry)\
**Replies:** 1\
**Last updated:** [June 2, 2023, 1:15am UTC](https://forum.onefinitycnc.com/t/jointcam-configuration/19033 "2023-06-02T01:15:33Z")
Just added downloadable configuration files for JointCAM, for both the Buildbotics and Masso controllers. http://g-forcecnc.com/jc\_downloads.html
---
## [JointCam Configuration page w/spindle](https://forum.onefinitycnc.com/t/jointcam-configuration-page-w-spindle/17582)
**Author:** [@WmColl46](https://forum.onefinitycnc.com/u/WmColl46)\
**Replies:** 0\
**Last updated:** [December 22, 2022, 9:44pm UTC](https://forum.onefinitycnc.com/t/jointcam-configuration-page-w-spindle/17582 "2022-12-22T21:44:29Z")
I’ve upgraded to an 80mm spindle. After a few “air” runs, I believe the following Configurations Work with JointCam.
---
## [Error Expected word or assignment, found Number '1' At: /var/lib/bbctrl/upload/123321.ngc:2:0](https://forum.onefinitycnc.com/t/error-expected-word-or-assignment-found-number-1-at-var-lib-bbctrl-upload-123321-ngc0/17563)
**Author:** [@GregoryG](https://forum.onefinitycnc.com/u/GregoryG)\
**Replies:** 0\
**Last updated:** [December 21, 2022, 11:35pm UTC](https://forum.onefinitycnc.com/t/error-expected-word-or-assignment-found-number-1-at-var-lib-bbctrl-upload-123321-ngc0/17563 "2022-12-21T23:35:59Z")
I have been trying to use Jointcam but when I upload gcode generated I get this Expected word or assignment, found Number '1' At: /var/lib/bbctrl/upload/123321.ngc:2:0