# Alarm Probe error

**URL:** https://forum.onefinitycnc.com/t/alarm-probe-error/24984
**Category:** Elite Series (Masso & Redline) (Gen 1)
**Created:** [January 28, 2024, 4:40am UTC](https://forum.onefinitycnc.com/t/alarm-probe-error/24984 "2024-01-28T04:40:22Z")
**Posts on this page:** 1
**Showing post:** 4

<div class="post-metadata">

### Author: ![349iq2345](https://avatars.discourse-cdn.com/v4/letter/3/bb73d2/32.png) [@349iq2345](https://forum.onefinitycnc.com/u/349iq2345)
#### Post date: [January 28, 2024, 12:52pm UTC](https://forum.onefinitycnc.com/t/alarm-probe-error/24984/4 "2024-01-28T12:52:15Z")

</div>

Hey Evens,

if you replace the [hand trim router](https://www.makitauk.com/product/rt0702c.html), which is a [class II double isolated](https://en.wikipedia.org/wiki/Appliance_classes#Class_II) device, that therefore needs the magnet end of the [XYZ touch plate](https://www.onefinitycnc.com/product-page/onefinity-3-axis-touch-probe) to make the collet and the bit part of an electrical circuit for the probing to work, by a spindle, which has to be properly grounded, you don’t need the magnet end of the XYZ touch plate anymore.

Furthermore, for probing with the XYZ touch plate to continue to function, you must make sure that the other wire is not connected to ground, but to the probe output. It may be that you need to use the other touch plate input pin on the CNC controller to connect your touch plate. [See here](https://forum.onefinitycnc.com/t/replacement-curly-cable/14837/7) for explanation.

Welcome to the forum!

---

_[View the full topic](https://forum.onefinitycnc.com/t/alarm-probe-error/24984)._