# All was good, now a Boat anchor (solved in comments) **URL:** \ **Category:** Original/PRO Series (Buildbotics) (Gen 1)\ **Created:** [August 15, 2024, 3:07pm UTC](https://forum.onefinitycnc.com/t/all-was-good-now-a-boat-anchor-solved-in-comments/28248 "2024-08-15T15:07:08Z")\ **Posts on this page:** 1\ **Showing post:** 2
**Author:** ![OnefinityCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/onefinitycnc/32/7_2.png) [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\ **Post date:** [August 15, 2024, 5:29pm UTC](https://forum.onefinitycnc.com/t/all-was-good-now-a-boat-anchor-solved-in-comments/28248/2 "2024-08-15T17:29:09Z")
**Please note the FILE vs FOLDER button. I think you are mixing the two up.** ![thumbnail_New Icon Screen v140](https://us1.discourse-cdn.com/flex022/uploads/onefinitycnc/original/3X/f/b/fb1ffc4595f1d98144072c95cc17742c40925187.png) * * * **1.5 will have words on the screen for claification:** > [@1.5 Beta 1 for BB Controllers (8/15/24) (Remember XYZ zeros upon reboot or estop) (Outdated)](https://forum.onefinitycnc.com/t/1-5-beta-1-for-bb-controllers-8-15-24-remember-xyz-zeros-upon-reboot-or-estop/28247): > > 1.5 beta 1 is not outdated. Find beta 2 here: [https://forum.onefinitycnc.com/t/1-5-beta-2-for-bb-controllers-8-31-24-set-time-and-date/28452](https://forum.onefinitycnc.com/t/1-5-beta-2-for-bb-controllers-8-31-24-set-time-and-date/28452) 8/15/24 1.5 Beta 1 This is the second release version of firmware 1.5 This is test firmware. As with all test/alpha/beta software, DO NOT INSTALL unless you like to be on the bleeding edge and can live with potential bugs. Beta 1 adds: NEW: Added text to the play, stop, load, ect buttons for clarification as many didn’t understand the difference bet… * * * **Sounds like you have EMI if the machine gets a mind of it’s own.** See: > [@EMI | Screen Flickering, Blank, or Black Screen, Randomly Loosing Zeros, Freezing, Disconnecting or Random Happenings](https://forum.onefinitycnc.com/t/emi-screen-flickering-blank-or-black-screen-randomly-loosing-zeros-freezing-disconnecting-or-random-happenings/14116): > > EMI, Flickering, Black or Blank screen, Random Axis motor alarms and axis movements: If you have verified you have the cables connected correctly (screen MUST be connected to wall power) and the screen is blinking on and off during a cut, you may be experiencing EMI. Ensure you have the controller and screen on one outlet, and the vacuum and spindle/router on a separate circuit/outlet. Usually this is enough to stop EMI. However, some extreme cases we’ve seen is: the separate circuits wired… --- _[View the full topic](https://forum.onefinitycnc.com/t/all-was-good-now-a-boat-anchor-solved-in-comments/28248)._