# BB not showing X-axis x50 Journeyman **URL:** \ **Category:** Controller (Buildbotics) Discussion\ **Created:** [March 15, 2024, 10:56pm UTC](https://forum.onefinitycnc.com/t/bb-not-showing-x-axis-x50-journeyman/25957 "2024-03-15T22:56:31Z")\ **Posts on this page:** 3\ **Page:** 1
**Author:** ![RandyS](https://avatars.discourse-cdn.com/v4/letter/r/8e7dd6/32.png) [@RandyS](https://forum.onefinitycnc.com/u/RandyS)\ **Post date:** [March 15, 2024, 10:56pm UTC](https://forum.onefinitycnc.com/t/bb-not-showing-x-axis-x50-journeyman/25957/1 "2024-03-15T22:56:31Z")
I started up the onefinity today, and the x-axis is not showing. I can jog the y, and when I jog the z, both the z and x move. I’ve checked the connections, rebooted them, and reinstalled the latest update, but the problem remains. I already ordered a set of new wires, just in case. I’m waiting for the Elite upgrade, but that’s at least seven weeks away, and I would like to be running something now. My thoughts are on the connections, but since the x-axis stepper motor runs when jogging the z-axis, I’m leaning toward an internal problem in the controller or software. Any ideas? ---
**Author:** ![OnefinityCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/onefinitycnc/32/7_2.png) [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\ **Post date:** [March 16, 2024, 1:41am UTC](https://forum.onefinitycnc.com/t/bb-not-showing-x-axis-x50-journeyman/25957/2 "2024-03-16T01:41:34Z")
Reset the configuration ---
**Author:** ![RandyS](https://avatars.discourse-cdn.com/v4/letter/r/8e7dd6/32.png) [@RandyS](https://forum.onefinitycnc.com/u/RandyS)\ **Post date:** [March 16, 2024, 4:33am UTC](https://forum.onefinitycnc.com/t/bb-not-showing-x-axis-x50-journeyman/25957/3 "2024-03-16T04:33:04Z")
That was it. I had fixed a stall homing issue and most of changed the motor, but I don’t remember doing it. Thanks