# Bug: incorrect toggle time units (Solved in version 1.4.7!) **URL:** \ **Category:** Bugs\ **Created:** [February 23, 2026, 6:05pm UTC](https://forum.onefinitycnc.com/t/bug-incorrect-toggle-time-units-solved-in-version-1-4-7/37558 "2026-02-23T18:05:18Z")\ **Posts on this page:** 3\ **Page:** 1
**Author:** ![SergeySatskiy](https://avatars.discourse-cdn.com/v4/letter/s/ea666f/32.png) [@SergeySatskiy](https://forum.onefinitycnc.com/u/SergeySatskiy)\ **Post date:** [February 23, 2026, 6:05pm UTC](https://forum.onefinitycnc.com/t/bug-incorrect-toggle-time-units-solved-in-version-1-4-7/37558/1 "2026-02-23T18:05:18Z")
Software/hardware: redline HMI 1.3.10 Steps: 1. boot HMI with default power up units set to metric (at config-\>general) 2. Navigate to config-\>motor drivers-\>x auxis 3. Note the displayed value for “Fine homing speed”. It displays -200.0 mm/min 4. Click on the “toggle time units” button at the bottom 5. Note the value of the “fine homing speed” field. It is -33.33mm/sec. This is incorrect because -200/60=3.33, not 33.3 The same behavior is observed for y and z auxis. A auxis behaves as expected. ---
**Author:** ![RTCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/rtcnc/32/33487_2.png) [@RTCNC](https://forum.onefinitycnc.com/u/RTCNC)\ **Post date:** [March 1, 2026, 7:57pm UTC](https://forum.onefinitycnc.com/t/bug-incorrect-toggle-time-units-solved-in-version-1-4-7/37558/2 "2026-03-01T19:57:47Z")
Thanks for this report. It has been fixed in our next hotfix release (1.4.7) which will be released today or tomorrow. ---
**Author:** ![OnefinityCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/onefinitycnc/32/7_2.png) [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\ **Post date:** [March 27, 2026, 3:19pm UTC](https://forum.onefinitycnc.com/t/bug-incorrect-toggle-time-units-solved-in-version-1-4-7/37558/3 "2026-03-27T15:19:56Z")
Solved in version 1.4.7!