Bug: incorrect toggle time units

Feature Requests Realtime Controller Bug & Software Request
1

Software/hardware: redline HMI 1.3.10

Steps:

  1. boot HMI with default power up units set to metric (at config->general)
  2. Navigate to config->motor drivers->x auxis
  3. Note the displayed value for “Fine homing speed”. It displays -200.0 mm/min
  4. Click on the “toggle time units” button at the bottom
  5. Note the value of the “fine homing speed” field. It is -33.33mm/sec. This is incorrect because -200/60=3.33, not 33.3

The same behavior is observed for y and z auxis. A auxis behaves as expected.

1 Like
2

Thanks for this report. It has been fixed in our next hotfix release (1.4.7) which will be released today or tomorrow.

1 Like