# Cable and Vac Management to start off

**URL:** https://forum.onefinitycnc.com/t/cable-and-vac-management-to-start-off/18753
**Category:** Accessories
**Created:** [February 12, 2023, 4:59pm UTC](https://forum.onefinitycnc.com/t/cable-and-vac-management-to-start-off/18753 "2023-02-12T16:59:03Z")
**Posts on this page:** 1
**Showing post:** 9

<div class="post-metadata">

### Author: ![349iq2345](https://avatars.discourse-cdn.com/v4/letter/3/bb73d2/32.png) [@349iq2345](https://forum.onefinitycnc.com/u/349iq2345)
#### Post date: [February 13, 2023, 9:06pm UTC](https://forum.onefinitycnc.com/t/cable-and-vac-management-to-start-off/18753/9 "2023-02-13T21:06:30Z")

</div>

Hey Pascal,

depending on what you plan later, 30 mm might be too small.

> [@Which machine to buy](https://forum.onefinitycnc.com/t/which-machine-to-buy/18784/2):
>
> the drag chain that is offered on the Elite is not announced to be wide enough for everything when you plan to use a water-cooled spindle later. See here for [width computation](https://forum.onefinitycnc.com/t/journeyman-x-50-drag-chain-addition/17984/2) for a drag chain.

---

_[View the full topic](https://forum.onefinitycnc.com/t/cable-and-vac-management-to-start-off/18753)._