# Cambam and mach3

**URL:** <https://forum.onefinitycnc.com/t/cambam-and-mach3/9022>\
**Category:** Uncategorized\
**Created:** [November 18, 2021, 6:54pm UTC](https://forum.onefinitycnc.com/t/cambam-and-mach3/9022 "2021-11-18T18:54:58Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![Grampsie5](https://avatars.discourse-cdn.com/v4/letter/g/ee59a6/32.png) [@Grampsie5](https://forum.onefinitycnc.com/u/Grampsie5)\
**Post date:** [November 18, 2021, 6:54pm UTC](https://forum.onefinitycnc.com/t/cambam-and-mach3/9022/1 "2021-11-18T18:54:58Z")

</div>

Can I use Cambam and mach3 with this machine?

---

<div class="post-metadata">

**Author:** ![OnefinityCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/onefinitycnc/32/7_2.png) [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\
**Post date:** [November 18, 2021, 6:56pm UTC](https://forum.onefinitycnc.com/t/cambam-and-mach3/9022/2 "2021-11-18T18:56:03Z")

</div>

Cambam might work with some generic grbl post processor. There is not a onefinity specific post p.

You cannot use mach 3 unless you retro fit a different controller.

---

<div class="post-metadata">

**Author:** ![Grampsie5](https://avatars.discourse-cdn.com/v4/letter/g/ee59a6/32.png) [@Grampsie5](https://forum.onefinitycnc.com/u/Grampsie5)\
**Post date:** [November 18, 2021, 6:58pm UTC](https://forum.onefinitycnc.com/t/cambam-and-mach3/9022/3 "2021-11-18T18:58:11Z")

</div>

Waht would you suggest to use other than mach 3

---

<div class="post-metadata">

**Author:** ![OnefinityCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/onefinitycnc/32/7_2.png) [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\
**Post date:** [November 18, 2021, 6:59pm UTC](https://forum.onefinitycnc.com/t/cambam-and-mach3/9022/4 "2021-11-18T18:59:47Z")

</div>

The built in controller software in our controller. There’s no need for any motion software as it’s already baked into our controller.