# Carve went off center then X axis jammed

**URL:** <https://forum.onefinitycnc.com/t/carve-went-off-center-then-x-axis-jammed/19368>\
**Category:** Troubleshooting (X35/X50)\
**Created:** [March 13, 2023, 1:19am UTC](https://forum.onefinitycnc.com/t/carve-went-off-center-then-x-axis-jammed/19368 "2023-03-13T01:19:20Z")\
**Posts on this page:** 1\
**Showing post:** 6

<div class="post-metadata">

**Author:** ![Atroz](https://avatars.discourse-cdn.com/v4/letter/a/958977/32.png) [@Atroz](https://forum.onefinitycnc.com/u/Atroz)\
**Post date:** [March 13, 2023, 2:40pm UTC](https://forum.onefinitycnc.com/t/carve-went-off-center-then-x-axis-jammed/19368/6 "2023-03-13T14:40:27Z")

</div>

I was talking about [this](https://forum.onefinitycnc.com/t/how-to-adjust-stall-homing-video/8529).

Might not be your problem but I was just thinking that perhaps it was seeing too much current draw and was stopping.

---

_[View the full topic](https://forum.onefinitycnc.com/t/carve-went-off-center-then-x-axis-jammed/19368)._