# Change tool setter position cases error **URL:** \ **Category:** Elite Series (Masso & Redline) (Gen 1)\ **Created:** [October 21, 2025, 7:54pm UTC](https://forum.onefinitycnc.com/t/change-tool-setter-position-cases-error/35914 "2025-10-21T19:54:37Z")\ **Posts on this page:** 3\ **Page:** 1
**Author:** ![tgunr](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/tgunr/32/10947_2.png) [@tgunr](https://forum.onefinitycnc.com/u/tgunr)\ **Post date:** [October 21, 2025, 7:54pm UTC](https://forum.onefinitycnc.com/t/change-tool-setter-position-cases-error/35914/1 "2025-10-21T19:54:37Z")
The Elite Series with @Redlinecnc Controller when setting tool change position then manually trying tool change I get an error ``G0G53X12.0Y4.0Z5.0` Machine travel exceeded` The coordinates are same as I set in the config. Evidently, working in G53 is not fully functional. ---
**Author:** ![RTCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/rtcnc/32/33487_2.png) [@RTCNC](https://forum.onefinitycnc.com/u/RTCNC)\ **Post date:** [October 21, 2025, 8:09pm UTC](https://forum.onefinitycnc.com/t/change-tool-setter-position-cases-error/35914/2 "2025-10-21T20:09:13Z")
G53 (Go to absolute machine coordinates) should be working. In your post, the error has Z5.0 which is either 5mm or 5” above the end of travel for the Z axis depending on which units you are using. This number should always be less than or equal to zero since the Z axis is a negative-going axis. i.e. It travels from 0 to a maximum of -160mm for a OneFinity Foreman. What are the coordinates you set for the tool setter position in the CONFIG screen? ---
**Author:** ![tgunr](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/tgunr/32/10947_2.png) [@tgunr](https://forum.onefinitycnc.com/u/tgunr)\ **Post date:** [October 21, 2025, 8:24pm UTC](https://forum.onefinitycnc.com/t/change-tool-setter-position-cases-error/35914/3 "2025-10-21T20:24:04Z")
I was in imperial G20 mode. Your correct, I was assuming the Z position incorrectly. Setting X=12, Y=4, Z=0 leave it at the top position as I wanted. Using Z=-1 causes it to move down 1” for anyone else who makes the same assumption.