# Cuts are 'stretched' along X axis

**URL:** <https://forum.onefinitycnc.com/t/cuts-are-stretched-along-x-axis/27779>\
**Category:** Troubleshooting (X35/X50)\
**Created:** [July 5, 2024, 11:51pm UTC](https://forum.onefinitycnc.com/t/cuts-are-stretched-along-x-axis/27779 "2024-07-05T23:51:55Z")\
**Posts on this page:** 1\
**Showing post:** 3

<div class="post-metadata">

**Author:** ![349iq2345](https://avatars.discourse-cdn.com/v4/letter/3/bb73d2/32.png) [@349iq2345](https://forum.onefinitycnc.com/u/349iq2345)\
**Post date:** [July 6, 2024, 1:23am UTC](https://forum.onefinitycnc.com/t/cuts-are-stretched-along-x-axis/27779/3 "2024-07-06T01:23:00Z")

</div>

Hey Logan,

Chris is right, you should choose the correct machine model on the ADMIN Page \> General \> Configuration \> Reset.

> [@Cutting Oblong circle](https://forum.onefinitycnc.com/t/cutting-oblong-circle/15076/2):
>
> do you have a [Journeyman X-50](https://www.onefinitycnc.com/product-page/onefinity-journeyman) or [Woodworker X-50](https://www.onefinitycnc.com/product-page/onefinity-woodworker-1), or an [Upgrade](https://www.onefinitycnc.com/upgradesinfo) to one of those? If so, those have a 1616 ballscrew on X Axis, but it could be that your Onefinity Controller is set to the default for a 1610 ballscrew (used on [Woodworker X-35](https://www.onefinitycnc.com/product-page/build-your-own-onefinity)). This would lead to a toolpath for a circle to be cut as an oval.
> 
> If this is the case, this error can be fixed on the [Motors Tab](https://buildbotics.com/manual-v1-0/#motorstab), on Motor “0” (which should be set to “X” axis), you have to edit the **`travel-per-rev`** setting from “10” to “16”, as is [explained here](https://forum.onefinitycnc.com/t/proper-motor-settings-for-x-50-rails-woodworker-and-journeyman-with-1616-ball-screw-configuration/7152). The setting for the other motors must remain at default value.

---

_[View the full topic](https://forum.onefinitycnc.com/t/cuts-are-stretched-along-x-axis/27779)._