# Drag Chain and wire gauge

**URL:** <https://forum.onefinitycnc.com/t/drag-chain-and-wire-gauge/9038>\
**Category:** Uncategorized\
**Created:** [November 20, 2021, 6:40pm UTC](https://forum.onefinitycnc.com/t/drag-chain-and-wire-gauge/9038 "2021-11-20T18:40:24Z")\
**Posts on this page:** 1\
**Showing post:** 19

<div class="post-metadata">

**Author:** ![349iq2345](https://avatars.discourse-cdn.com/v4/letter/3/bb73d2/32.png) [@349iq2345](https://forum.onefinitycnc.com/u/349iq2345)\
**Post date:** [November 23, 2021, 8:26am UTC](https://forum.onefinitycnc.com/t/drag-chain-and-wire-gauge/9038/19 "2021-11-23T08:26:42Z")

</div>

Hey Andy, hey Ziggy, hey all,

@Dr-Al [had the cable attached from the ceiling at that moment](https://forum.onefinitycnc.com/t/new-member-new-journeyman-drag-chains-dust-collection-spindle-grounding/8183/20) which I find a fast and quick solution.

One youtube link that I posted [in the same thread](https://forum.onefinitycnc.com/t/new-member-new-journeyman-drag-chains-dust-collection-spindle-grounding/8183/27) has been clicked many times, it shows [a simple solution if you find drag chains too complicated](https://youtu.be/lU0iZKajpoo?t=629).

Note that for the cable it is better to be bent on different parts over its entire length (like in the drag chain) than always on the same part (as shown in the video).

---

_[View the full topic](https://forum.onefinitycnc.com/t/drag-chain-and-wire-gauge/9038)._