# E-stop won't reset after moving spindle height up

**URL:** <https://forum.onefinitycnc.com/t/e-stop-wont-reset-after-moving-spindle-height-up/30906>\
**Category:** Elite Series (Masso & Redline) (Gen 1)\
**Created:** [February 13, 2025, 4:43am UTC](https://forum.onefinitycnc.com/t/e-stop-wont-reset-after-moving-spindle-height-up/30906 "2025-02-13T04:43:36Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![GRAINHAUS](https://avatars.discourse-cdn.com/v4/letter/g/c0e974/32.png) [@GRAINHAUS](https://forum.onefinitycnc.com/u/GRAINHAUS)\
**Post date:** [February 13, 2025, 4:43am UTC](https://forum.onefinitycnc.com/t/e-stop-wont-reset-after-moving-spindle-height-up/30906/1 "2025-02-13T04:43:36Z")

</div>

Long story short, here are the steps I took and the issues I ran into along the way.

Been cutting fine for a month, needed to carve a 2" piece, and had to move the spindle mount up to clear the workpiece.

I moved the spindle up and went to rehome, but obviously, the bit didn’t drop enough on the EZ tool setter to zero out the Z height. Tried to adjust the EZ tool settings in the F1 menu to drop the setting from -1 to -2 to see if that worked for hitting the EZ tool setter. It did not. Seemed to get to the bottom of travel and boom, got a motor alarm for the Z motor.

Tried multiple times to reboot and rehome, but same thing. Now it has triggered an E-stop alarm that I cannot reset, even with the E-stop button. Reboot does the same thing. Currently stuck, not being able to clear the E-stop alarm.

I’ve checked all the motor red/black wires and all are properly set. No red motor alarm lights, I’m stumped.

Thanks for the help!

Jon

---

<div class="post-metadata">

**Author:** ![GRAINHAUS](https://avatars.discourse-cdn.com/v4/letter/g/c0e974/32.png) [@GRAINHAUS](https://forum.onefinitycnc.com/u/GRAINHAUS)\
**Post date:** [February 13, 2025, 6:25pm UTC](https://forum.onefinitycnc.com/t/e-stop-wont-reset-after-moving-spindle-height-up/30906/2 "2025-02-13T18:25:18Z")

</div>

Onefinity support helped me quick!

Looks like I had E-stop F1 function in Low instead of High, I switched it, don’t do that. Switched it back and was able to clear the error and rehome.