# Eazy-Z Tool Setter Settings Change (if it doesn't move down in Z when commanded) **URL:** \ **Category:** Tool Setter\ **Created:** [January 2, 2024, 4:05pm UTC](https://forum.onefinitycnc.com/t/eazy-z-tool-setter-settings-change-if-it-doesnt-move-down-in-z-when-commanded/24422 "2024-01-02T16:05:22Z")\ **Posts on this page:** 2\ **Page:** 1
**Author:** ![OnefinityCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/onefinitycnc/32/7_2.png) [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\ **Post date:** [January 2, 2024, 4:05pm UTC](https://forum.onefinitycnc.com/t/eazy-z-tool-setter-settings-change-if-it-doesnt-move-down-in-z-when-commanded/24422/1 "2024-01-02T16:05:22Z")
The Tool Setter settings in the F1 page should be green/low. If yours is set to red/high, follow the steps below to adjust. - Go to the f1 page. - [Leave the password blank.](https://forum.onefinitycnc.com/t/what-is-the-password-for-the-masso-controller-faq/20191) - Hit enter. - Scroll down in the center column. - Find Input 11 line labeled “tool setter”. - Single tap that line so that it is highlighted. Do not double tap the line. - Push the space bar to change it from red/high to green/low. Ensure it is green/low for correct operation. - Reboot the machine and try again. ![tool setter high](https://us1.discourse-cdn.com/flex022/uploads/onefinitycnc/original/3X/7/e/7e11c38a56aefd24f2cd1e477407ff123bcd1ff2.jpeg) ---
**Author:** ![OnefinityCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/onefinitycnc/32/7_2.png) [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\ **Post date:** [January 2, 2024, 4:05pm UTC](https://forum.onefinitycnc.com/t/eazy-z-tool-setter-settings-change-if-it-doesnt-move-down-in-z-when-commanded/24422/2 "2024-01-02T16:05:26Z")
Closed on January 2, 2024, 4:05pm UTC