# Elite Table Builds **URL:** \ **Category:** Elite Series (Masso & Redline) (Gen 1)\ **Created:** [January 19, 2023, 12:52am UTC](https://forum.onefinitycnc.com/t/elite-table-builds/18240 "2023-01-19T00:52:45Z")\ **Posts on this page:** 1\ **Showing post:** 82
**Author:** ![RockingMallet](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/rockingmallet/32/22313_2.png) [@RockingMallet](https://forum.onefinitycnc.com/u/RockingMallet)\ **Post date:** [April 10, 2023, 2:55am UTC](https://forum.onefinitycnc.com/t/elite-table-builds/18240/82 "2023-04-10T02:55:54Z")
Posted table with elite journeyman mounted finally on another thread. > [@Table size for the Elite Journeyman 48" x 32"](https://forum.onefinitycnc.com/t/table-size-for-the-elite-journeyman-48-x-32/19701/6): > > Ok. Took some photos today how my elite journeyman sits on a 48x64 top. Its tight. But i also dont have much room and was designing to the inch to get it tot fit. Spoke with OF support and wont be able to flip x/y until they get extension cables made so will have to live with the original setup for awhile which is fine. It works. So far no issues with the table size… me operating said machine is a different story all together. The table wobbles way more than i like and will end up putting leg… Its tight. Would recommmend going a couple inches wider at least. Also will need to add some stability to it. Wobbles back and forth more than i like. Seems to work fine but would just lile more rigidity. Also not able to flip x&y like i was planning until extension cables are available… not a huge deal. --- _[View the full topic](https://forum.onefinitycnc.com/t/elite-table-builds/18240)._