# Ellipse no circle **URL:** \ **Category:** Troubleshooting (X35/X50)\ **Created:** [February 19, 2022, 12:25am UTC](https://forum.onefinitycnc.com/t/ellipse-no-circle/11309 "2022-02-19T00:25:47Z")\ **Posts on this page:** 1\ **Showing post:** 2
**Author:** ![WaywardWoodworker](https://avatars.discourse-cdn.com/v4/letter/w/e79b87/32.png) [@WaywardWoodworker](https://forum.onefinitycnc.com/u/WaywardWoodworker)\ **Post date:** [February 19, 2022, 12:57am UTC](https://forum.onefinitycnc.com/t/ellipse-no-circle/11309/2 "2022-02-19T00:57:16Z")
Take a look at this link, it shows how to update the settings for the X axis and ensure the travel-per-rev and soft limits are set appropriately for the journeyman. > [@Proper Motor Settings for x-50 rails (Woodworker and Journeyman), with 1616 ball screw configuration](https://forum.onefinitycnc.com/t/proper-motor-settings-for-x-50-rails-woodworker-and-journeyman-with-1616-ball-screw-configuration/7152): > > UPDATE: With the release of 1.0.9 firmware, these settings are now part of the default configuartion. Ensure you are on 1.0.9 firmware ([https://forum.onefinitycnc.com/t/firmware-update-1-0-9-12-17-21-latest-release/84830](https://forum.onefinitycnc.com/t/firmware-update-1-0-9-12-17-21-latest-release/84830)) or later and then reset the configuration, choosing your correct machine configuration: [How To Reset The Configuration To Defaults](https://forum.onefinitycnc.com/t/how-to-reset-the-configuration-to-defaults/2547) (OLD) These settings only apply to X-50 Woodworker and Journeyman with the 1616 ballscrew configuration. Please note: these settings are in M… --- _[View the full topic](https://forum.onefinitycnc.com/t/ellipse-no-circle/11309)._