# Endmill pulling out of router

**URL:** <https://forum.onefinitycnc.com/t/endmill-pulling-out-of-router/19989>\
**Category:** Uncategorized\
**Created:** [April 12, 2023, 6:41pm UTC](https://forum.onefinitycnc.com/t/endmill-pulling-out-of-router/19989 "2023-04-12T18:41:20Z")\
**Posts on this page:** 1\
**Showing post:** 7

<div class="post-metadata">

**Author:** ![349iq2345](https://avatars.discourse-cdn.com/v4/letter/3/bb73d2/32.png) [@349iq2345](https://forum.onefinitycnc.com/u/349iq2345)\
**Post date:** [April 13, 2023, 12:10am UTC](https://forum.onefinitycnc.com/t/endmill-pulling-out-of-router/19989/7 "2023-04-13T00:10:24Z")

</div>

Hey Butch,

there is no ER collet for the Makita hand trim router, you would need to either buy a spindle, or Onefinity would release a Z slider for what I call the [Best milling motor solution for hobbyists and semiprofessionals](https://forum.onefinitycnc.com/t/introducing-the-new-onefinity-elite-series-powered-by-masso/16706/115#best-milling-motor-solution-for-hobbyists-and-semiprofessionals-1), a slider e.g. [like shown here](https://forum.onefinitycnc.com/t/43mm-euro-spindle/15188/28) so you could use the [FM 1000 **PV** ER](https://produkte.mafell.de/en/mortising/milling-motor/milling-motor-fm-1000-pv-er) (with [ER collet](https://forum.onefinitycnc.com/t/how-do-you-ensure-your-model-translates-to-reality/13579/24#the-er-collet-1)). It also has speed control interface.

---

_[View the full topic](https://forum.onefinitycnc.com/t/endmill-pulling-out-of-router/19989)._