# Extension Cables

**URL:** <https://forum.onefinitycnc.com/t/extension-cables/33944>\
**Category:** Elite Series (Masso & Redline) (Gen 1)\
**Created:** [June 16, 2025, 2:36pm UTC](https://forum.onefinitycnc.com/t/extension-cables/33944 "2025-06-16T14:36:02Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![Plunk](https://avatars.discourse-cdn.com/v4/letter/p/54ee81/32.png) [@Plunk](https://forum.onefinitycnc.com/u/Plunk)\
**Post date:** [June 16, 2025, 2:36pm UTC](https://forum.onefinitycnc.com/t/extension-cables/33944/1 "2025-06-16T14:36:02Z")

</div>

I wanted to move my Masso Controller and Power Distribution from the Left Front to the Right Front, so I ordered the Full Set of 4’ Extension Cables. It’s 52 inches inside the Y1/B1 rail, and since there is very little slack for the Y1, X, and Z cables the 48" cables don’t reach - especially if you are routing cables under the table for cable management. Onefinity’s response is we can’t anticipate “every” senario, and their solution is order another set of $200 cables…they should have made them a minimum of 7ft. to provide a reasonable amount of flexibility in moving the controller. Now I’m into it for $400…Sorry Onefinity you missed it on this one.