# Gcode Simulation Feedrate Question

**URL:** <https://forum.onefinitycnc.com/t/gcode-simulation-feedrate-question/27863>\
**Category:** Elite Series (Masso & Redline) (Gen 1)\
**Created:** [July 13, 2024, 1:25pm UTC](https://forum.onefinitycnc.com/t/gcode-simulation-feedrate-question/27863 "2024-07-13T13:25:01Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![AndyP](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/andyp/32/1106_2.png) [@AndyP](https://forum.onefinitycnc.com/u/AndyP)\
**Post date:** [July 14, 2024, 1:34am UTC](https://forum.onefinitycnc.com/t/gcode-simulation-feedrate-question/27863/2 "2024-07-14T01:34:37Z")

</div>

This might help. It is for the buildbotics controller, but I believe it should be helpful in Elite Masso, as I expect the Masso will not change the run times.

:[BB / 1F Test Application - #2 by OnefinityCNC](https://forum.onefinitycnc.com/t/bb-1f-test-application/24907/2)

![BB Tester - 1720922562226](https://us1.discourse-cdn.com/flex022/uploads/onefinitycnc/original/3X/3/8/384dbef289c704a0a542133f80fd82e052384427.gif)

---

_[View the full topic](https://forum.onefinitycnc.com/t/gcode-simulation-feedrate-question/27863)._