# Generic gcode for aspire

**URL:** <https://forum.onefinitycnc.com/t/generic-gcode-for-aspire/7565>\
**Category:** Uncategorized\
**Created:** [September 5, 2021, 12:16am UTC](https://forum.onefinitycnc.com/t/generic-gcode-for-aspire/7565 "2021-09-05T00:16:37Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Garry](https://avatars.discourse-cdn.com/v4/letter/g/bb73d2/32.png) [@Garry](https://forum.onefinitycnc.com/u/Garry)\
**Post date:** [September 5, 2021, 12:16am UTC](https://forum.onefinitycnc.com/t/generic-gcode-for-aspire/7565/1 "2021-09-05T00:16:37Z")

</div>

new machine owner just got it all up and running but…

I have an old version of aspire and it will not recognize the oneinfinity no jet post processor  
is there a generic PP I can use instead

---

<div class="post-metadata">

**Author:** ![pootaholic](https://avatars.discourse-cdn.com/v4/letter/p/8e7dd6/32.png) [@pootaholic](https://forum.onefinitycnc.com/u/pootaholic)\
**Post date:** [September 5, 2021, 7:41am UTC](https://forum.onefinitycnc.com/t/generic-gcode-for-aspire/7565/2 "2021-09-05T07:41:43Z")

</div>

Welcome Garry

You could download & install from this link or use the generic GRBL post processor.

> [@Vectric Post Processors For 10.5 or older versions (Download Links Included)](https://forum.onefinitycnc.com/t/vectric-post-processors-download-links-included/640):
>
> 7/21/2021: Vectric V11 is out now. The Onefinity machines and post processors are now included in the software and do not require being manually downloaded into the program! There is now a machine configuration management selection pop up box that allows you to select the Onefinity and the specific machine configuration you have. You should only need to download the below post processors if you are using V10.5 or below. PP UPDATED 12/16/2020 Here releases of the Post Processors for Vectric…