# Holy Gee Whiz WTF!

**URL:** <https://forum.onefinitycnc.com/t/holy-gee-whiz-wtf/20211>\
**Category:** Elite Series (Masso & Redline) (Gen 1)\
**Created:** [April 22, 2023, 8:15pm UTC](https://forum.onefinitycnc.com/t/holy-gee-whiz-wtf/20211 "2023-04-22T20:15:45Z")\
**Posts on this page:** 1\
**Showing post:** 33

<div class="post-metadata">

**Author:** ![349iq2345](https://avatars.discourse-cdn.com/v4/letter/3/bb73d2/32.png) [@349iq2345](https://forum.onefinitycnc.com/u/349iq2345)\
**Post date:** [April 25, 2023, 11:50am UTC](https://forum.onefinitycnc.com/t/holy-gee-whiz-wtf/20211/33 "2023-04-25T11:50:28Z")

</div>

Hey all,

again,

- [Z Axis Moving Unexpectedly (Cutting too shallow or too deep)](https://forum.onefinitycnc.com/t/z-axis-moving-unexpectedly-cutting-too-shallow-or-too-deep/14829)
- [Troubleshooting: Rail is getting hung, stuck, or out of alignment (x35/x50 machines)](https://forum.onefinitycnc.com/t/troubleshooting-rail-is-getting-hung-stuck-or-out-of-alignment-x35-x50-machines/10826)

You use the **two** wrenches hopefully, and not the red button and one wrench? Note that the red button can block and fail and make the router unusable.

---

_[View the full topic](https://forum.onefinitycnc.com/t/holy-gee-whiz-wtf/20211)._