# Holy Gee Whiz WTF!

**URL:** <https://forum.onefinitycnc.com/t/holy-gee-whiz-wtf/20211>\
**Category:** Elite Series (Masso & Redline) (Gen 1)\
**Created:** [April 22, 2023, 8:15pm UTC](https://forum.onefinitycnc.com/t/holy-gee-whiz-wtf/20211 "2023-04-22T20:15:45Z")\
**Posts on this page:** 1\
**Showing post:** 5

<div class="post-metadata">

**Author:** ![349iq2345](https://avatars.discourse-cdn.com/v4/letter/3/bb73d2/32.png) [@349iq2345](https://forum.onefinitycnc.com/u/349iq2345)\
**Post date:** [April 22, 2023, 10:57pm UTC](https://forum.onefinitycnc.com/t/holy-gee-whiz-wtf/20211/5 "2023-04-22T22:57:46Z")

</div>

Hey Dan,

> [@DaddyDan](#):
>
> today I wanted to surface the spoilboard. Opened carveco maker and continued to make a surfacing tool path.

depends on what your g-code is programmed to do. If you share it, forum members could have a look at it.

> [@DaddyDan](#):
>
> After probing xyz it started off center

How do you probed that?

> [@Spoilboard HELP!](https://forum.onefinitycnc.com/t/spoilboard-help/19986/2):
>
> The manufacturer offers these support videos:
> 
> - [How To Position A Wasteboard Inside The Cutting Area on the Onefinity CNC](https://www.youtube.com/watch?v=rJXG1df09w4&list=PLlCbxVoOUWYVqLId1iNXb_Nt85CDnA1VJ&index=2)
> - [Flattening A Wasteboard On the Onefinity CNC](https://www.youtube.com/watch?v=1Ao6ZvdUEr4&list=PLlCbxVoOUWYVqLId1iNXb_Nt85CDnA1VJ&index=1)

If you think your issue is a **Z axis that does not do what you programmed it to** , there are these answers in the [FAQ/Troubleshooting section](https://forum.onefinitycnc.com/c/faq/troubleshooting/45):

> [@Raised Band on Finishing Pass](https://forum.onefinitycnc.com/t/raised-band-on-finishing-pass/20162/2):
>
> - [Z Axis Moving Unexpectedly (Cutting too shallow or too deep)](https://forum.onefinitycnc.com/t/z-axis-moving-unexpectedly-cutting-too-shallow-or-too-deep/14829)
> - [Troubleshooting: Rail is getting hung, stuck, or out of alignment (x35/x50 machines)](https://forum.onefinitycnc.com/t/troubleshooting-rail-is-getting-hung-stuck-or-out-of-alignment-x35-x50-machines/10826)

---

_[View the full topic](https://forum.onefinitycnc.com/t/holy-gee-whiz-wtf/20211)._