# Homing after zeroed

**URL:** <https://forum.onefinitycnc.com/t/homing-after-zeroed/15709>\
**Category:** Uncategorized\
**Created:** [October 6, 2022, 4:39pm UTC](https://forum.onefinitycnc.com/t/homing-after-zeroed/15709 "2022-10-06T16:39:36Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![Animas-Guitars](https://avatars.discourse-cdn.com/v4/letter/a/65b543/32.png) [@Animas-Guitars](https://forum.onefinitycnc.com/u/Animas-Guitars)\
**Post date:** [October 6, 2022, 4:39pm UTC](https://forum.onefinitycnc.com/t/homing-after-zeroed/15709/1 "2022-10-06T16:39:36Z")

</div>

I home my machine then zero my left lower corner of my work piece. When I start the program my machine returns to the home position again and then starts the run.

---

<div class="post-metadata">

**Author:** ![OldNewbie](https://avatars.discourse-cdn.com/v4/letter/o/6f9a4e/32.png) [@OldNewbie](https://forum.onefinitycnc.com/u/OldNewbie)\
**Post date:** [October 6, 2022, 6:57pm UTC](https://forum.onefinitycnc.com/t/homing-after-zeroed/15709/2 "2022-10-06T18:57:42Z")

</div>

Do you use the probe for x & y or do you use the paper method???

---

<div class="post-metadata">

**Author:** ![Animas-Guitars](https://avatars.discourse-cdn.com/v4/letter/a/65b543/32.png) [@Animas-Guitars](https://forum.onefinitycnc.com/u/Animas-Guitars)\
**Post date:** [October 6, 2022, 7:12pm UTC](https://forum.onefinitycnc.com/t/homing-after-zeroed/15709/3 "2022-10-06T19:12:24Z")

</div>

Both. Same problem with each

---

<div class="post-metadata">

**Author:** ![Dr-Al](https://avatars.discourse-cdn.com/v4/letter/d/cc9497/32.png) [@Dr-Al](https://forum.onefinitycnc.com/u/Dr-Al)\
**Post date:** [October 6, 2022, 9:56pm UTC](https://forum.onefinitycnc.com/t/homing-after-zeroed/15709/4 "2022-10-06T21:56:58Z")

</div>

It sounds like your code is telling it to go there. Post the first few lines of your g code.