# Homing issues - how to cancel?

**URL:** <https://forum.onefinitycnc.com/t/homing-issues-how-to-cancel/19916>\
**Category:** Elite Series (Masso & Redline) (Gen 1)\
**Created:** [April 8, 2023, 3:24pm UTC](https://forum.onefinitycnc.com/t/homing-issues-how-to-cancel/19916 "2023-04-08T15:24:40Z")\
**Posts on this page:** 1\
**Showing post:** 19

<div class="post-metadata">

**Author:** ![349iq2345](https://avatars.discourse-cdn.com/v4/letter/3/bb73d2/32.png) [@349iq2345](https://forum.onefinitycnc.com/u/349iq2345)\
**Post date:** [April 9, 2023, 9:15pm UTC](https://forum.onefinitycnc.com/t/homing-issues-how-to-cancel/19916/19 "2023-04-09T21:15:06Z")

</div>

Hey Pat,

to square a machine with limit sensors when you have two Y drivers (Y and B software-slaved on the Masso) and therefore two Y limit sensors, you can adjust the rectangularity (“squaring”) by moving one sensor back or forth by the amount that your machine is out of square [(see also here)](https://forums.masso.com.au/threads/axis-auto-squaring.2330/#post-17057). However, I think it’s good on assembly of the machine to make the machine as square as possible. [See here](https://forum.onefinitycnc.com/t/what-do-i-do-first/18349/6) for checking and adjusting rectangularity (“squaring”).

#### Further reading

- [Slave Axis – Masso documentation](https://docs.masso.com.au/wiring-and-setup/setup-and-calibration/slave-axis)
- [Hardware slaving vs. Software slaving explained by CNCNutz](https://www.youtube.com/watch?v=-neGqeUWyrE)

---

_[View the full topic](https://forum.onefinitycnc.com/t/homing-issues-how-to-cancel/19916)._