# Hot set the Probe

**URL:** <https://forum.onefinitycnc.com/t/hot-set-the-probe/18237>\
**Category:** Firmware (BB Buildbotics) (Discontinued)\
**Created:** [January 18, 2023, 11:30pm UTC](https://forum.onefinitycnc.com/t/hot-set-the-probe/18237 "2023-01-18T23:30:34Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![pmck](https://avatars.discourse-cdn.com/v4/letter/p/e56c9b/32.png) [@pmck](https://forum.onefinitycnc.com/u/pmck)\
**Post date:** [January 18, 2023, 11:30pm UTC](https://forum.onefinitycnc.com/t/hot-set-the-probe/18237/1 "2023-01-18T23:30:34Z")

</div>

How can I set the probe to connect, it was working but has now stopped,

---

<div class="post-metadata">

**Author:** ![Atroz](https://avatars.discourse-cdn.com/v4/letter/a/958977/32.png) [@Atroz](https://forum.onefinitycnc.com/u/Atroz)\
**Post date:** [January 18, 2023, 11:35pm UTC](https://forum.onefinitycnc.com/t/hot-set-the-probe/18237/2 "2023-01-18T23:35:21Z")

</div>

> [@Checking Touch Probe Connectivity](https://forum.onefinitycnc.com/t/checking-touch-probe-connectivity/667):
>
> [[Checking Touch Probe Connectivity] ](https://www.youtube.com/watch?v=Uyr2IAOGOXM) This video describes how to test if your touch probe is connected and working correctly.

---

<div class="post-metadata">

**Author:** ![pmck](https://avatars.discourse-cdn.com/v4/letter/p/e56c9b/32.png) [@pmck](https://forum.onefinitycnc.com/u/pmck)\
**Post date:** [January 19, 2023, 8:55pm UTC](https://forum.onefinitycnc.com/t/hot-set-the-probe/18237/3 "2023-01-19T20:55:16Z")

</div>

Hi,  
Tried a new probe and all works, old probe has bad connection.  
Regards

From “Atroz via Onefinity CNC Forum” \<[notifications@onefinitycnc.discoursemail.com](mailto:notifications@onefinitycnc.discoursemail.com)\>  
To [pm@silab.co.nz](mailto:pm@silab.co.nz)  
Date 19/01/2023 12:45:26 pm  
Subject [Onefinity CNC Forum] [Firmware (Buildbotics)] Hot set the Probe

---

<div class="post-metadata">

**Author:** ![Atroz](https://avatars.discourse-cdn.com/v4/letter/a/958977/32.png) [@Atroz](https://forum.onefinitycnc.com/u/Atroz)\
**Post date:** [January 19, 2023, 9:11pm UTC](https://forum.onefinitycnc.com/t/hot-set-the-probe/18237/4 "2023-01-19T21:11:40Z")

</div>

You can buy just the cable, or make a new one.