# I have attempted a video
**URL:** https://forum.onefinitycnc.com/t/i-have-attempted-a-video/26391
**Category:** Spindle/VFD (Aftermarket/Unsupported)
**Created:** [April 9, 2024, 4:05pm UTC](https://forum.onefinitycnc.com/t/i-have-attempted-a-video/26391 "2024-04-09T16:05:22Z")
**Posts on this page:** 2
**Page:** 1
### Author:  [@CandL](https://forum.onefinitycnc.com/u/CandL)
#### Post date: [April 9, 2024, 4:05pm UTC](https://forum.onefinitycnc.com/t/i-have-attempted-a-video/26391/1 "2024-04-09T16:05:22Z")
There have been a few folks interested in my Elite Forman ISO-30 ATC build. I promised videos so here is the first… be kind.
The video talks about runout and why it is important. It then goes on to show the actual runout I am getting.
Let me point out I am not trying to sell anything; these are just my opinions. Could I have bought better gear, absolutely, but this is the gear and cost I could justify.
A link to the video: [OneFinity Elite Foreman with CNCDepot IS0-30 ATC spindle … runout acceptance test (youtube.com)](https://www.youtube.com/watch?v=e2WnlFaLdO4&t=82s)
I hope this video adds value.
What else would you like to know about this setup.
---
### Author:  [@CandL](https://forum.onefinitycnc.com/u/CandL)
#### Post date: [May 14, 2024, 12:41pm UTC](https://forum.onefinitycnc.com/t/i-have-attempted-a-video/26391/2 "2024-05-14T12:41:53Z")
Video 2 just went out:
- Table top construction & mounting
- ATC rack design and operation
[ ](https://www.youtube.com/watch?v=mc-X8X3l7uM)