# Installing the Jtech 44 watt Laser on my Masso Elite **URL:** \ **Category:** Uncategorized\ **Created:** [April 6, 2024, 8:12pm UTC](https://forum.onefinitycnc.com/t/installing-the-jtech-44-watt-laser-on-my-masso-elite/26354 "2024-04-06T20:12:01Z")\ **Posts on this page:** 1\ **Page:** 1
**Author:** ![DCC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/dcc/32/10577_2.png) [@DCC](https://forum.onefinitycnc.com/u/DCC)\ **Post date:** [April 6, 2024, 8:12pm UTC](https://forum.onefinitycnc.com/t/installing-the-jtech-44-watt-laser-on-my-masso-elite/26354/1 "2024-04-06T20:12:01Z")
I am finally getting to my Onefinity Masso Elite and Jtech 44 Watt Laser install- and of course there are challenges.- Has anyone successfully done this recently and would willing to share their tips and tricks? I have been watching the Jtech guy on the YouTube video explain it- but he isn’t working with a 44 watt and for some reason I don’t see the same screens as he has.- In particular when i go into the F1. Setup and go to output 11- It does not offer me a selection of Laser Engraver- many other options but no Laser engraver- The closest one to it is the Laser-Air Assist. Next issue is the power button and toggle switch- when following his instructions and making certain that the switch is moved toward the LED side -When I turn it on it is no where near a low setting- It immediately starts to burn through my table surface/waste board. I did place the aluminum shield on next (yeah- should of done it’s first) but it is still way powerful in both positions and both LEDs stay on in both positions… Yikes- I need help. Anybody out there and active today?