# J Tech dual pro 14w laser not firing?

**URL:** <https://forum.onefinitycnc.com/t/j-tech-dual-pro-14w-laser-not-firing/16006>\
**Category:** Uncategorized\
**Created:** [October 20, 2022, 4:27pm UTC](https://forum.onefinitycnc.com/t/j-tech-dual-pro-14w-laser-not-firing/16006 "2022-10-20T16:27:50Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![PDMcLardy](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/pdmclardy/32/10740_2.png) [@PDMcLardy](https://forum.onefinitycnc.com/u/PDMcLardy)\
**Post date:** [October 20, 2022, 4:27pm UTC](https://forum.onefinitycnc.com/t/j-tech-dual-pro-14w-laser-not-firing/16006/1 "2022-10-20T16:27:50Z")

</div>

Hi All  
Newby here, just installed the J Tech 14w laser to my Onefinty CNC, I’ve followed all the video’s but can’t get the laser to fire ?  
The fans turn on and I can get it to test fire by turning the switch next to the two green lights on and off, i have tried resetting, but no joy.  
it does not respond to any of the M3 S10 commands all the way up to M3 S100  
if trying a G-Code made up in Lightburn the Onefinity goes through the motions but no Laser.  
the firmware on the Onefinity is 1.0.9  
Am I missing something ?  
TIA  
Peter

---

<div class="post-metadata">

**Author:** ![OnefinityCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/onefinitycnc/32/7_2.png) [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\
**Post date:** [October 20, 2022, 4:36pm UTC](https://forum.onefinitycnc.com/t/j-tech-dual-pro-14w-laser-not-firing/16006/2 "2022-10-20T16:36:33Z")

</div>

s100 is only 10% fire rate.

Try s1000, that is 100% fire rate.
