# Jog Zslider (installation)
**URL:** https://forum.onefinitycnc.com/t/jog-zslider-installation/31887
**Category:** Elite Series (Masso & Redline) (Gen 1)
**Created:** [March 23, 2025, 10:36pm UTC](https://forum.onefinitycnc.com/t/jog-zslider-installation/31887 "2025-03-23T22:36:30Z")
**Posts on this page:** 3
**Page:** 1
### Author:  [@mkyb14](https://forum.onefinitycnc.com/u/mkyb14)
#### Post date: [March 23, 2025, 10:36pm UTC](https://forum.onefinitycnc.com/t/jog-zslider-installation/31887/1 "2025-03-23T22:36:30Z")
assembling my elite foreman and at the stage in the new instructions for installing the zslider and says to job it, but it will not budge. The video skips right over it to show it in the moved up position. I can’t find any other video’s or how to do this. Applying upward force on the router clamp of the zslider has no play what so ever and the cork-screw drive does not move.
---
### Author:  [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)
#### Post date: [March 23, 2025, 11:20pm UTC](https://forum.onefinitycnc.com/t/jog-zslider-installation/31887/2 "2025-03-23T23:20:32Z")
The manual has updated to reflect the braking motor is standard. Check the manual.
---
### Author:  [@mkyb14](https://forum.onefinitycnc.com/u/mkyb14)
#### Post date: [March 24, 2025, 12:25am UTC](https://forum.onefinitycnc.com/t/jog-zslider-installation/31887/3 "2025-03-24T00:25:42Z")
understood, I was using the video to move through the steps.