# Journeyman Pro Footprint

**URL:** <https://forum.onefinitycnc.com/t/journeyman-pro-footprint/23955>\
**Category:** Original/PRO Series (Buildbotics) (Gen 1)\
**Created:** [December 12, 2023, 8:42pm UTC](https://forum.onefinitycnc.com/t/journeyman-pro-footprint/23955 "2023-12-12T20:42:23Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![sjandrews](https://avatars.discourse-cdn.com/v4/letter/s/b5a626/32.png) [@sjandrews](https://forum.onefinitycnc.com/u/sjandrews)\
**Post date:** [December 12, 2023, 8:42pm UTC](https://forum.onefinitycnc.com/t/journeyman-pro-footprint/23955/1 "2023-12-12T20:42:24Z")

</div>

Can you please tell me the footprint for the Journeyman Pro? I’d like to start building a table to support/mount it to.

Thanks,

---

<div class="post-metadata">

**Author:** ![349iq2345](https://avatars.discourse-cdn.com/v4/letter/3/bb73d2/32.png) [@349iq2345](https://forum.onefinitycnc.com/u/349iq2345)\
**Post date:** [December 13, 2023, 7:29am UTC](https://forum.onefinitycnc.com/t/journeyman-pro-footprint/23955/2 "2023-12-13T07:29:52Z")

</div>

Hey Scott,

Journeyman Pro and Elite share the same footprint, except that the X motor protruding on the right is longer on Elite. See links below.

> [@Just curious...Elite Woodworker](https://forum.onefinitycnc.com/t/just-curious-elite-woodworker/23566/3):
>
> See here for
> 
> - [Journeyman table size](https://forum.onefinitycnc.com/t/cable-and-vac-management-to-start-off/18753/14)
> - [Space to reserve around the machine](https://forum.onefinitycnc.com/t/1st-post-size-matters-and-vertical-clamping-for-finger-joints-tenons/18074/3)
> - [Size of physical table actually needed](https://forum.onefinitycnc.com/t/cable-and-vac-management-to-start-off/18753/14)
> - [Drag Chain width computation](https://forum.onefinitycnc.com/t/journeyman-x-50-drag-chain-addition/17984/2)