# Journeyman X50 Setup **URL:** \ **Category:** Machine Setups\ **Created:** [October 16, 2021, 5:56pm UTC](https://forum.onefinitycnc.com/t/journeyman-x50-setup/8317 "2021-10-16T17:56:53Z")\ **Posts on this page:** 1\ **Showing post:** 9
**Author:** ![349iq2345](https://avatars.discourse-cdn.com/v4/letter/3/bb73d2/32.png) [@349iq2345](https://forum.onefinitycnc.com/u/349iq2345)\ **Post date:** [October 17, 2021, 3:20pm UTC](https://forum.onefinitycnc.com/t/journeyman-x50-setup/8317/9 "2021-10-17T15:20:14Z")
Hey Bob, > [@Bob\_D](#): > > I also ordered the QCW from above frame and the leveling system. I don’t see how you can setup the machine without leveling out the rails. It seems to me that all four corners need to be in the same plane else the rails will be racked. > > You can measure them diagonally and they might agree but that is only checking that the frame is square. It says nothing about if one or more feet are at a different elevation than the others. And if they are then you will introduce twist into the spindle as it travels along the rails. _You got exactly to the point_ of what is important in an assembly base for the Onefinity. Besides the **rectangularity between the axes** , the **planeness of the assembly surface** is crucial for the Onefinity CNC producing accurate results. This was [last discussed here](https://forum.onefinitycnc.com/t/qcw-video-posted/7470/4), but the QCW frames had not yet been delivered. (cyberreefguru had a prototype). I’m still waiting for it. Mathematically, **three points in space are always in one plane** (a table with three feet can not wobble). So in order to make sure our Onefinity CNC is not twisted, we need to check whether the fourth foot is in the same plane as the three others. There are at least three methods to check this that I know, but since I’m still waiting for the QCW Frame (and also I unfortunately have not enought time and room to do these things at the moment), I planned to check this in the future and to report it here then (under a topic like “How do I make sure my QCW Frame or Table Top is not twisted?” or similar). One of the question I asked myself at that time was: > [@QCW Video Posted](https://forum.onefinitycnc.com/t/qcw-video-posted/7470/6): > > That would be the next, the third interesting point: If your table is not plan, is the QCW Frame able to stay plan when it has to bear the load of the machine, the wasteboard and the workpiece? **Is the QCW Frame stiffy, rigid enough** to not adopt skewness/warping of the underlying table or ground? > > In the promo [video](https://www.youtube.com/watch?v=y0k6UUGZ6yw) of [Any Surface Leveling System](https://www.onefinitycnc.com/product-page/any-surface-leveling-system) (that no one should forget to order together with the QCW Frame) it is offered a solution to ensure planeness of the frame on uneven grounds - but the question is, **is the QCW Frame able to retain planeness by itself?** Or is the Any Surface Leveling System necessary _because it is not_ ? Still I have no answer since I’m still waiting for the QCW Frame. --- _[View the full topic](https://forum.onefinitycnc.com/t/journeyman-x50-setup/8317)._