# Joypad mode support

**URL:** <https://forum.onefinitycnc.com/t/joypad-mode-support/20065>\
**Category:** Firmware (BB Buildbotics) (Discontinued)\
**Created:** [April 16, 2023, 12:44pm UTC](https://forum.onefinitycnc.com/t/joypad-mode-support/20065 "2023-04-16T12:44:51Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![Mwaldrop](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/mwaldrop/32/21675_2.png) [@Mwaldrop](https://forum.onefinitycnc.com/u/Mwaldrop)\
**Post date:** [April 16, 2023, 12:44pm UTC](https://forum.onefinitycnc.com/t/joypad-mode-support/20065/1 "2023-04-16T12:44:51Z")

</div>

I have been looking through firmware release notes and am a little confused. I think the I’ll fated 1.1.1 build included a feature to make all modes of the Onefinity provided joypad work to jog X-y-and z.

I am not sure if this feature has been included or planned for later builds ?

Also, are there any workarounds that avoid the process of getting the joypad into the correct mode every power up ? It is a small thing, but quite annoying.

Thank you.