# Leveling the Fixed Leg Table

**URL:** <https://forum.onefinitycnc.com/t/leveling-the-fixed-leg-table/28799>\
**Category:** Quick Change Wasteboard Frame\
**Created:** [September 28, 2024, 10:47pm UTC](https://forum.onefinitycnc.com/t/leveling-the-fixed-leg-table/28799 "2024-09-28T22:47:24Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![Kaiju](https://avatars.discourse-cdn.com/v4/letter/k/a587f6/32.png) [@Kaiju](https://forum.onefinitycnc.com/u/Kaiju)\
**Post date:** [September 28, 2024, 10:47pm UTC](https://forum.onefinitycnc.com/t/leveling-the-fixed-leg-table/28799/1 "2024-09-28T22:47:24Z")

</div>

I’ve been unable to find a manual or instruction video (other than the announcement video) for the QWC Woodworker Fixed Leg Table. Using the rolling table instructions I was able to figure out how to build it, but I’m struggling with the leveling feet which are significantly different from any style I’ve see before.

Has anyone had any experience with leveling the fixed leg stand that they could share with me or send me a reference to an instruction manual or video that is relevant to the fixed leg stand?

Many thanks!

---

<div class="post-metadata">

**Author:** ![dfrederick144](https://avatars.discourse-cdn.com/v4/letter/d/74df32/32.png) [@dfrederick144](https://forum.onefinitycnc.com/u/dfrederick144)\
**Post date:** [December 13, 2024, 1:03pm UTC](https://forum.onefinitycnc.com/t/leveling-the-fixed-leg-table/28799/2 "2024-12-13T13:03:59Z")

</div>

@Kaiju, did you ever figure out how to work the leveling feet on the fixed leg stand?

TIA Dan

---

<div class="post-metadata">

**Author:** ![dfrederick144](https://avatars.discourse-cdn.com/v4/letter/d/74df32/32.png) [@dfrederick144](https://forum.onefinitycnc.com/u/dfrederick144)\
**Post date:** [December 13, 2024, 1:25pm UTC](https://forum.onefinitycnc.com/t/leveling-the-fixed-leg-table/28799/3 "2024-12-13T13:25:29Z")

</div>

Never mind, just extremely tight from the factory.

---

<div class="post-metadata">

**Author:** ![Kaiju](https://avatars.discourse-cdn.com/v4/letter/k/a587f6/32.png) [@Kaiju](https://forum.onefinitycnc.com/u/Kaiju)\
**Post date:** [December 13, 2024, 9:20pm UTC](https://forum.onefinitycnc.com/t/leveling-the-fixed-leg-table/28799/4 "2024-12-13T21:20:45Z")

</div>

LOL… yup, that was the exact problem. A little extra elbow grease got it done for me too!