# Looking for some advice

**URL:** <https://forum.onefinitycnc.com/t/looking-for-some-advice/3450>\
**Category:** Original/PRO Series (Buildbotics) (Gen 1)\
**Created:** [February 10, 2021, 6:49pm UTC](https://forum.onefinitycnc.com/t/looking-for-some-advice/3450 "2021-02-10T18:49:04Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![BMWBUD](https://avatars.discourse-cdn.com/v4/letter/b/58956e/32.png) [@BMWBUD](https://forum.onefinitycnc.com/u/BMWBUD)\
**Post date:** [February 10, 2021, 6:49pm UTC](https://forum.onefinitycnc.com/t/looking-for-some-advice/3450/1 "2021-02-10T18:49:04Z")

</div>

Currently am running a ShopBot Desktop 18x24. VCarvePro10 on a pc with a pc monitor.

Can I use the same PC and software on the OF? If so, is it plug and play or will I have to do other things as well?

Thanks in advance.

---

<div class="post-metadata">

**Author:** ![Machinist](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/machinist/32/36465_2.png) [@Machinist](https://forum.onefinitycnc.com/u/Machinist)\
**Post date:** [February 11, 2021, 3:41pm UTC](https://forum.onefinitycnc.com/t/looking-for-some-advice/3450/2 "2021-02-11T15:41:33Z")

</div>

The Onefinity controller is a stand-alone controller, meaning it does not interface or require a PC. The only thing you really need a PC for is to create your models & run whatever software for creating the toolpaths (in your case Vcarve).