# Losing the origin in the middle of the cut. EMI?

**URL:** <https://forum.onefinitycnc.com/t/losing-the-origin-in-the-middle-of-the-cut-emi/21222>\
**Category:** Spindle/VFD (Aftermarket/Unsupported)\
**Created:** [June 26, 2023, 11:58am UTC](https://forum.onefinitycnc.com/t/losing-the-origin-in-the-middle-of-the-cut-emi/21222 "2023-06-26T11:58:27Z")\
**Posts on this page:** 1\
**Showing post:** 3

<div class="post-metadata">

**Author:** ![349iq2345](https://avatars.discourse-cdn.com/v4/letter/3/bb73d2/32.png) [@349iq2345](https://forum.onefinitycnc.com/u/349iq2345)\
**Post date:** [June 26, 2023, 12:25pm UTC](https://forum.onefinitycnc.com/t/losing-the-origin-in-the-middle-of-the-cut-emi/21222/3 "2023-06-26T12:25:34Z")

</div>

Hey Tim,

I would check the points in this support document one by one:

- [Troubleshooting: Rail is getting hung, stuck, or out of alignment (x35/x50 machines)](https://forum.onefinitycnc.com/t/troubleshooting-rail-is-getting-hung-stuck-or-out-of-alignment-x35-x50-machines/10826)

Also did you check that your machine is [rectangular](https://forum.onefinitycnc.com/t/what-do-i-do-first/18349/6)? If it is not, the gantry can block.

---

_[View the full topic](https://forum.onefinitycnc.com/t/losing-the-origin-in-the-middle-of-the-cut-emi/21222)._