# Machine settings seem to be off

**URL:** <https://forum.onefinitycnc.com/t/machine-settings-seem-to-be-off/30948>\
**Category:** Elite Series (Masso & Redline) (Gen 1)\
**Created:** [February 15, 2025, 10:59pm UTC](https://forum.onefinitycnc.com/t/machine-settings-seem-to-be-off/30948 "2025-02-15T22:59:48Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![OnefinityCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/onefinitycnc/32/7_2.png) [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\
**Post date:** [February 16, 2025, 1:12am UTC](https://forum.onefinitycnc.com/t/machine-settings-seem-to-be-off/30948/2 "2025-02-16T01:12:37Z")

</div>

Check the dip switches, then reload the configuration!

> [@Elite Series Masso Default Machine Settings](https://forum.onefinitycnc.com/t/elite-series-masso-default-machine-settings/17451):
>
> Elite Series Masso Machine Settings: (updated: 11/3/25) Part 1, 2, and 3 must be done in order. :one:Part 1: Firmware Before performing the two steps below, ensure the Masso firmware is 5.13 or later ([Click Here to learn how to update your firmware, which is different than the below config reset](https://docs.masso.com.au/getting-started-guides/installing-masso/loading-software-to-masso-touch)) :down\_arrow:Watch the video below to learn how to update the firmware of the Masso Controller down_arrow[[Load software on your MASSO Touch - MASSO Top Tip 6] ](https://www.youtube.com/watch?v=1jgQOGZrI8M) Loading these settings w…

---

_[View the full topic](https://forum.onefinitycnc.com/t/machine-settings-seem-to-be-off/30948)._