# Makita 1/4" factory collet loose

**URL:** <https://forum.onefinitycnc.com/t/makita-1-4-factory-collet-loose/8870>\
**Category:** Accessories\
**Created:** [November 12, 2021, 12:11am UTC](https://forum.onefinitycnc.com/t/makita-1-4-factory-collet-loose/8870 "2021-11-12T00:11:47Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![CrazieBird](https://avatars.discourse-cdn.com/v4/letter/c/977dab/32.png) [@CrazieBird](https://forum.onefinitycnc.com/u/CrazieBird)\
**Post date:** [November 12, 2021, 12:11am UTC](https://forum.onefinitycnc.com/t/makita-1-4-factory-collet-loose/8870/1 "2021-11-12T00:11:47Z")

</div>

Whenever I try to install a bit I need 3 hands, 1 to hold the bit, 2 to tighten the two wretches. Any idea how to better deal with this? Also, I remember watching a video that said the proper collet insertion depth was to have the end of the bit shaft just short of the bottom of the collet, is this accurate?

---

<div class="post-metadata">

**Author:** ![JimHatch](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/jimhatch/32/3928_2.png) [@JimHatch](https://forum.onefinitycnc.com/u/JimHatch)\
**Post date:** [November 12, 2021, 12:50am UTC](https://forum.onefinitycnc.com/t/makita-1-4-factory-collet-loose/8870/2 "2021-11-12T00:50:38Z")

</div>

If you take the collet out along with the nut (really should so you can clear any sawdust out of the vanes/slots of the collet which will keep it from tightening securely), then hold the nut between your thumb & forefinger while your fingers curl around the bit. Then screw the nut onto the shaft with your thumb & forefinger while pushing the shaft lock button in with your other hand.

Snug it with your thumb & forefinger. Then adjust the bit up or down until there is about 1/16 or 1/8" between the collet and the end of the flutes. That will keep the sawdust & chips from riding up the flutes into the collet.

Then take your wrenches and tighten the nuts. I tighten mine more than I would with an ER16 or 20 collet because of the way the Makita collet is made. But remember you will have to loosen them some time soon 😅
