# Masso SC5/SC7 no voltage

**URL:** <https://forum.onefinitycnc.com/t/masso-sc5-sc7-no-voltage/28206>\
**Category:** Spindle/VFD (Aftermarket/Unsupported)\
**Created:** [August 11, 2024, 6:53pm UTC](https://forum.onefinitycnc.com/t/masso-sc5-sc7-no-voltage/28206 "2024-08-11T18:53:15Z")\
**Posts on this page:** 1\
**Showing post:** 3

<div class="post-metadata">

**Author:** ![349iq2345](https://avatars.discourse-cdn.com/v4/letter/3/bb73d2/32.png) [@349iq2345](https://forum.onefinitycnc.com/u/349iq2345)\
**Post date:** [August 27, 2024, 11:22am UTC](https://forum.onefinitycnc.com/t/masso-sc5-sc7-no-voltage/28206/3 "2024-08-27T11:22:53Z")

</div>

Hey Shane,

an [optocoupler](https://en.wikipedia.org/wiki/Opto-isolator) by itself is no source of voltage, it is like a electronically controlled switch. Usually you take the voltage separately and lead them through them. You could use the +DC supplied by the Controller and then switch something this way.

See also

- [Checking Optocouplers – Masso Documentation](https://docs.masso.com.au/troubleshooting-guides/checking-optocouplers)

- [VFD Spindle Examples – Masso Documentation](https://docs.masso.com.au/wiring-and-setup/setup-and-calibration/spindle-vfd-examples)

---

_[View the full topic](https://forum.onefinitycnc.com/t/masso-sc5-sc7-no-voltage/28206)._
