# Microjig Matchfit Waste board for Woodworker on QCW

**URL:** <https://forum.onefinitycnc.com/t/microjig-matchfit-waste-board-for-woodworker-on-qcw/35365>\
**Category:** Wasteboard\
**Created:** [September 10, 2025, 3:16am UTC](https://forum.onefinitycnc.com/t/microjig-matchfit-waste-board-for-woodworker-on-qcw/35365 "2025-09-10T03:16:48Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![rhsmgunn](https://avatars.discourse-cdn.com/v4/letter/r/2acd7d/32.png) [@rhsmgunn](https://forum.onefinitycnc.com/u/rhsmgunn)\
**Post date:** [September 10, 2025, 3:16am UTC](https://forum.onefinitycnc.com/t/microjig-matchfit-waste-board-for-woodworker-on-qcw/35365/1 "2025-09-10T03:16:48Z")

</div>

Hi all,

I have set up a waste board using the Microjig Matchfit system for our Elite wood workers. Have attached the .f3d file. Could be of use, but use with caution and double check everything will work with your setup.

All tool paths are sorted will just need to adapt for your own tools. Have also added notes on each setup to help with where to add work offsets.

[Onefinity\_Woodworker\_Matchfit\_WasteBoard.f3d](https://forum.onefinitycnc.com/uploads/short-url/8YiDP7gtXJ55BshZJb6ZJBCjoPE.f3d) (435.4 KB)