# My table with vertical holding

**URL:** <https://forum.onefinitycnc.com/t/my-table-with-vertical-holding/14133>\
**Category:** Machine Setups\
**Created:** [July 14, 2022, 6:05pm UTC](https://forum.onefinitycnc.com/t/my-table-with-vertical-holding/14133 "2022-07-14T18:05:11Z")\
**Posts on this page:** 1\
**Showing post:** 7

<div class="post-metadata">

**Author:** ![WaywardWoodworker](https://avatars.discourse-cdn.com/v4/letter/w/e79b87/32.png) [@WaywardWoodworker](https://forum.onefinitycnc.com/u/WaywardWoodworker)\
**Post date:** [July 14, 2022, 9:28pm UTC](https://forum.onefinitycnc.com/t/my-table-with-vertical-holding/14133/7 "2022-07-14T21:28:21Z")

</div>

It looks nice, one suggestion I’ll make is to give yourself some material on the fixed side of the clamping fixture that you can machine parallel with the Onefinity once it’s mounted to correct any out of parallel/square that might exist in the table. If I build another table I’d change my clamping fixture to be parallel to the Y axis instead of the X axis as I’ve had 2 occasions where the operator didn’t ensure the X axis was squared before running through 100 bd ft of lumber… a not parallel axis turns out wonky drawers 😉

---

_[View the full topic](https://forum.onefinitycnc.com/t/my-table-with-vertical-holding/14133)._