# My X axis thinks it is longer than it is and my Y is short on carves

**URL:** <https://forum.onefinitycnc.com/t/my-x-axis-thinks-it-is-longer-than-it-is-and-my-y-is-short-on-carves/7639>\
**Category:** Uncategorized\
**Created:** [September 9, 2021, 2:40pm UTC](https://forum.onefinitycnc.com/t/my-x-axis-thinks-it-is-longer-than-it-is-and-my-y-is-short-on-carves/7639 "2021-09-09T14:40:38Z")\
**Posts on this page:** 1\
**Showing post:** 9

<div class="post-metadata">

**Author:** ![OnefinityCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/onefinitycnc/32/7_2.png) [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\
**Post date:** [September 13, 2021, 2:17pm UTC](https://forum.onefinitycnc.com/t/my-x-axis-thinks-it-is-longer-than-it-is-and-my-y-is-short-on-carves/7639/9 "2021-09-13T14:17:17Z")

</div>

95% of the time, monitor issues are because it’s not connected correctly. Take a look at this: [10.8" Monitor: How to connect it to power and the controller](https://forum.onefinitycnc.com/t/10-8-monitor-how-to-connect-it-to-power-and-the-controller/5081)

---

_[View the full topic](https://forum.onefinitycnc.com/t/my-x-axis-thinks-it-is-longer-than-it-is-and-my-y-is-short-on-carves/7639)._