# N2000 Gcode display

**URL:** <https://forum.onefinitycnc.com/t/n2000-gcode-display/27606>\
**Category:** Controller (MASSO) Discussion\
**Created:** [June 24, 2024, 2:09am UTC](https://forum.onefinitycnc.com/t/n2000-gcode-display/27606 "2024-06-24T02:09:28Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![David272](https://avatars.discourse-cdn.com/v4/letter/d/5e9695/32.png) [@David272](https://forum.onefinitycnc.com/u/David272)\
**Post date:** [June 24, 2024, 2:09am UTC](https://forum.onefinitycnc.com/t/n2000-gcode-display/27606/1 "2024-06-24T02:09:28Z")

</div>

Can anyone tell me why my Masso controller only shows the first 2000 lines of gcode, the onefinity keeps going, just not the display of gcode. I’m assuming I set something up wrong, but not sure how to fix it.

---

<div class="post-metadata">

**Author:** ![TMToronto](https://avatars.discourse-cdn.com/v4/letter/t/7ea924/32.png) [@TMToronto](https://forum.onefinitycnc.com/u/TMToronto)\
**Post date:** [June 24, 2024, 2:24am UTC](https://forum.onefinitycnc.com/t/n2000-gcode-display/27606/2 "2024-06-24T02:24:45Z")

</div>

> [@Masso G3 Touch Elite](https://forum.onefinitycnc.com/t/masso-g3-touch-elite/25275):
>
> OK, does anyone know whats the deal with the Masso G3 touch g code preview. It scrolls as the code/Job is running but when it hits greater then 2000 lines the preview stops but the job continues ok? Line count at the top keep moving but preview just stops? New Elite Foreman with firmware 5.06

---

<div class="post-metadata">

**Author:** ![TMToronto](https://avatars.discourse-cdn.com/v4/letter/t/7ea924/32.png) [@TMToronto](https://forum.onefinitycnc.com/u/TMToronto)\
**Post date:** [June 24, 2024, 2:30am UTC](https://forum.onefinitycnc.com/t/n2000-gcode-display/27606/3 "2024-06-24T02:30:08Z")

</div>

[https://forums.masso.com.au/threads/active-line-tracking.3388/#post-24788](https://forums.masso.com.au/threads/active-line-tracking.3388/#post-24788)