# Pen Plotter Specs

**URL:** <https://forum.onefinitycnc.com/t/pen-plotter-specs/40266>\
**Category:** Uncategorized\
**Created:** [September 27, 2026, 6:40pm UTC](https://forum.onefinitycnc.com/t/pen-plotter-specs/40266 "2026-09-27T18:40:14Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![ppd417](https://avatars.discourse-cdn.com/v4/letter/p/9dc877/32.png) [@ppd417](https://forum.onefinitycnc.com/u/ppd417)\
**Post date:** [September 27, 2026, 6:40pm UTC](https://forum.onefinitycnc.com/t/pen-plotter-specs/40266/1 "2026-09-27T18:40:14Z")

</div>

Decided to try pen plotting with my Gen 2 Elite Woodworker. I downloaded and printed a pen holder from Myers Woodshop Etsy then mounted it. No problems there. I’m using VCarve Pro, how do I set it up to draw within the program? Do I set my X, Y & Z the same as when using bits? What about the depth/pressure of the pen tip?

---

<div class="post-metadata">

**Author:** ![SailorMike](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/sailormike/32/3290_2.png) [@SailorMike](https://forum.onefinitycnc.com/u/SailorMike)\
**Post date:** [September 27, 2026, 7:42pm UTC](https://forum.onefinitycnc.com/t/pen-plotter-specs/40266/2 "2026-09-27T19:42:41Z")

</div>

See my post here:

> [@A New Pen Plotter](https://forum.onefinitycnc.com/t/a-new-pen-plotter/40113/15):
>
> As soon as I read your reply, I realized I already had a set of those. That’s a great idea!

I describe my setup in detail. Hopefully, your new attachment is spring-loaded. I’ve had bad luck with those that weren’t.

In short, make a tool as described for your tool database. I’ve attached a picture of mine. Note that you’ll have to experiment with pass depth to get results from your particular setup.

 ![Plot Tool](https://us1.discourse-cdn.com/flex022/uploads/onefinitycnc/original/3X/5/2/5207dcd2a2d57efa39161943c1485960685ae271.jpeg)

---

<div class="post-metadata">

**Author:** ![ppd417](https://avatars.discourse-cdn.com/v4/letter/p/9dc877/32.png) [@ppd417](https://forum.onefinitycnc.com/u/ppd417)\
**Post date:** [September 27, 2026, 8:42pm UTC](https://forum.onefinitycnc.com/t/pen-plotter-specs/40266/3 "2026-09-27T20:42:09Z")

</div>

Thanks Mike, I’ll give your settings a try.

Paul
