# Probing inbetween Tool Changes

**URL:** <https://forum.onefinitycnc.com/t/probing-inbetween-tool-changes/3647>\
**Category:** Original/PRO Series (Buildbotics) (Gen 1)\
**Created:** [February 18, 2021, 12:12pm UTC](https://forum.onefinitycnc.com/t/probing-inbetween-tool-changes/3647 "2021-02-18T12:12:08Z")\
**Posts on this page:** 1\
**Showing post:** 50

<div class="post-metadata">

**Author:** ![349iq2345](https://avatars.discourse-cdn.com/v4/letter/3/bb73d2/32.png) [@349iq2345](https://forum.onefinitycnc.com/u/349iq2345)\
**Post date:** [December 24, 2022, 2:44am UTC](https://forum.onefinitycnc.com/t/probing-inbetween-tool-changes/3647/50 "2022-12-24T02:44:22Z")

</div>

Hey all,

you see what’s in the ‘tool change’ field of the SETTINGS tab? This is what makes you’re stuck over your workpiece at the tool change event with not enough room to actually change the bit. Here’s [how to make this ‘tool change’ routine usable](https://forum.onefinitycnc.com/t/tool-changes-and-z-height/7715/15#making-the-tool-change-routine-usable-1). (thanks to @raziullah007 🙂 already mentioned above)

---

_[View the full topic](https://forum.onefinitycnc.com/t/probing-inbetween-tool-changes/3647)._