# Program Error Message

**URL:** <https://forum.onefinitycnc.com/t/program-error-message/7338>\
**Category:** Uncategorized\
**Created:** [August 22, 2021, 8:37pm UTC](https://forum.onefinitycnc.com/t/program-error-message/7338 "2021-08-22T20:37:19Z")\
**Posts on this page:** 5\
**Page:** 1

<div class="post-metadata">

**Author:** ![WickedKnot](https://avatars.discourse-cdn.com/v4/letter/w/aeb1de/32.png) [@WickedKnot](https://forum.onefinitycnc.com/u/WickedKnot)\
**Post date:** [August 22, 2021, 8:37pm UTC](https://forum.onefinitycnc.com/t/program-error-message/7338/1 "2021-08-22T20:37:19Z")

</div>

I am receiving an error message that says

“Cannot enter running cycle while in MDI cycle”

How do I clear this?

---

<div class="post-metadata">

**Author:** ![WaywardWoodworker](https://avatars.discourse-cdn.com/v4/letter/w/e79b87/32.png) [@WaywardWoodworker](https://forum.onefinitycnc.com/u/WaywardWoodworker)\
**Post date:** [August 23, 2021, 2:46am UTC](https://forum.onefinitycnc.com/t/program-error-message/7338/2 "2021-08-23T02:46:16Z")

</div>

Not sure, I’ve not run into it but I’ll put in my 2 cents. if you change to the MDI tab you can no longer run a program on the ‘auto’ tab. Do you possibly have the web interface open on another computer while you’re trying to control it from the display?

---

<div class="post-metadata">

**Author:** ![ShamRocker](https://avatars.discourse-cdn.com/v4/letter/s/ea666f/32.png) [@ShamRocker](https://forum.onefinitycnc.com/u/ShamRocker)\
**Post date:** [August 23, 2021, 2:08pm UTC](https://forum.onefinitycnc.com/t/program-error-message/7338/3 "2021-08-23T14:08:08Z")

</div>

Were you probing for Z before this happened?

---

<div class="post-metadata">

**Author:** ![OnefinityCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/onefinitycnc/32/7_2.png) [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\
**Post date:** [August 23, 2021, 3:36pm UTC](https://forum.onefinitycnc.com/t/program-error-message/7338/4 "2021-08-23T15:36:54Z")

</div>

Usually, a restart of the controller will clear it.

---

<div class="post-metadata">

**Author:** ![WickedKnot](https://avatars.discourse-cdn.com/v4/letter/w/aeb1de/32.png) [@WickedKnot](https://forum.onefinitycnc.com/u/WickedKnot)\
**Post date:** [August 23, 2021, 3:40pm UTC](https://forum.onefinitycnc.com/t/program-error-message/7338/5 "2021-08-23T15:40:13Z")

</div>

Thanks for the responses. Onefinity was correct and a reboot cleared the error!