# Redline Realtime RTS-X Software Recommended System Requirements

**URL:** <https://forum.onefinitycnc.com/t/redline-realtime-rts-x-software-recommended-system-requirements/37037>\
**Category:** Firmware FAQs\
**Created:** [December 30, 2025, 10:40pm UTC](https://forum.onefinitycnc.com/t/redline-realtime-rts-x-software-recommended-system-requirements/37037 "2025-12-30T22:40:32Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![OnefinityCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/onefinitycnc/32/7_2.png) [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\
**Post date:** [December 30, 2025, 10:40pm UTC](https://forum.onefinitycnc.com/t/redline-realtime-rts-x-software-recommended-system-requirements/37037/1 "2025-12-30T22:40:32Z")

</div>

If you are not using the HMI to controller your Redline Realtime Motion controller for your Gen 2 Elite or Apprentice Onefinity CNC machines, these are the minimum specs for a PC/Laptop to run the software:

 ![RTS-X Software System Requirements](https://us1.discourse-cdn.com/flex022/uploads/onefinitycnc/original/3X/d/8/d89753a668a8f52425dfac0e4c40dd6a22b2527f.png)

**Lower End Laptop Examples:**

[HP Laptop](https://amzn.to/4oIVBQr?tag=benmyers-20)

[Dell Laptop](https://amzn.to/3XIkzUX?tag=benmyers-20)

[Asus Laptop](https://amzn.to/4oL1i01?tag=benmyers-20)

[Lenovo Laptop](https://amzn.to/3XE6V5k?tag=benmyers-20)