# Resetting a carve

**URL:** <https://forum.onefinitycnc.com/t/resetting-a-carve/40289>\
**Category:** Troubleshooting (Elite Series)\
**Created:** [October 1, 2026, 2:51pm UTC](https://forum.onefinitycnc.com/t/resetting-a-carve/40289 "2026-10-01T14:51:22Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Davel](https://avatars.discourse-cdn.com/v4/letter/d/898d66/32.png) [@Davel](https://forum.onefinitycnc.com/u/Davel)\
**Post date:** [October 1, 2026, 2:51pm UTC](https://forum.onefinitycnc.com/t/resetting-a-carve/40289/1 "2026-10-01T14:51:23Z")

</div>

Hi all, I finally made a stupid error after almost two years. I set up a 3D carve but I forgot a step prior to the 3D roughing and ended up having the wrong bit in place starting the carve. I had done everything except the final cycle start and wanted to cancel everything and set it up again. Is there a “cancel” available? I could not find anything that would get me out of the carve, even the emergency stop. Eventually I resorted to a power off which I did not like. Any ideas? Thanks.

---

<div class="post-metadata">

**Author:** ![SailorMike](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/sailormike/32/3290_2.png) [@SailorMike](https://forum.onefinitycnc.com/u/SailorMike)\
**Post date:** [October 1, 2026, 10:34pm UTC](https://forum.onefinitycnc.com/t/resetting-a-carve/40289/2 "2026-10-01T22:34:22Z")

</div>

Hi David; What controller do you have? I know on my Redline there is a big red “Abort” button on the top of the controller screen while the program is running. I’ve had to use it a couple of times, it does what it says…

---

<div class="post-metadata">

**Author:** ![PezWoodworks](https://avatars.discourse-cdn.com/v4/letter/p/ea5d25/32.png) [@PezWoodworks](https://forum.onefinitycnc.com/u/PezWoodworks)\
**Post date:** [October 2, 2026, 12:54pm UTC](https://forum.onefinitycnc.com/t/resetting-a-carve/40289/3 "2026-10-02T12:54:33Z")

</div>

On my Masso I can rewind the Gcode.

Pat