# Rotary "Keep Out" Zone?

**URL:** https://forum.onefinitycnc.com/t/rotary-keep-out-zone/29177
**Category:** Onefinity Rotary 4th Axis 'The Revolution'
**Created:** [November 2, 2024, 4:11pm UTC](https://forum.onefinitycnc.com/t/rotary-keep-out-zone/29177 "2024-11-02T16:11:26Z")
**Posts on this page:** 4
**Page:** 1

<div class="post-metadata">

### Author: ![Bern](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/bern/32/7185_2.png) [@Bern](https://forum.onefinitycnc.com/u/Bern)
#### Post date: [November 2, 2024, 4:11pm UTC](https://forum.onefinitycnc.com/t/rotary-keep-out-zone/29177/1 "2024-11-02T16:11:26Z")

</div>

I finished installing and setting up a rotary on my Woodworker Elite (on QCW with rolling folding stand). I have mine oriented along the Y Axis, with the rotary in the right front and tail piece in right rear. I am thinking I may want to leave it permanent, but I would risk a crash on the rotary in the right front. Is it possible to configure the Masso with a “Keep Out” zone where the rotary is to avoid any possible “mistakes”.

I tried searching the forum, but TBH, I wasn’t sure what language to use.

---

<div class="post-metadata">

### Author: ![PezWoodworks](https://avatars.discourse-cdn.com/v4/letter/p/ea5d25/32.png) [@PezWoodworks](https://forum.onefinitycnc.com/u/PezWoodworks)
#### Post date: [November 2, 2024, 4:53pm UTC](https://forum.onefinitycnc.com/t/rotary-keep-out-zone/29177/2 "2024-11-02T16:53:29Z")

</div>

You can adjust your soft limits to avoid it but have to reset them when you use the rotary.  
Pat

---

<div class="post-metadata">

### Author: ![TMToronto](https://avatars.discourse-cdn.com/v4/letter/t/7ea924/32.png) [@TMToronto](https://forum.onefinitycnc.com/u/TMToronto)
#### Post date: [November 2, 2024, 8:34pm UTC](https://forum.onefinitycnc.com/t/rotary-keep-out-zone/29177/3 "2024-11-02T20:34:24Z")

</div>

This request has come up in the Masso forum, but I do not believe it is scheduled for any upcoming firmware releases. Phase 1 of BETA (v5.100b) has been out for over 12 months, and there were phases 2 and 3 still to go as part of the rollout. So, not likely any time soon.

---

<div class="post-metadata">

### Author: ![Bern](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/bern/32/7185_2.png) [@Bern](https://forum.onefinitycnc.com/u/Bern)
#### Post date: [November 4, 2024, 2:17pm UTC](https://forum.onefinitycnc.com/t/rotary-keep-out-zone/29177/4 "2024-11-04T14:17:29Z")

</div>

Thanks for the reply. I am starting to lurk around in the Masso forum, lot’s of good stuff over there.