# Sagging Drag Chains **URL:** \ **Category:** Elite Series (Masso & Redline) (Gen 1)\ **Created:** [September 5, 2023, 1:11am UTC](https://forum.onefinitycnc.com/t/sagging-drag-chains/22230 "2023-09-05T01:11:04Z")\ **Posts on this page:** 1\ **Showing post:** 27
**Author:** ![349iq2345](https://avatars.discourse-cdn.com/v4/letter/3/bb73d2/32.png) [@349iq2345](https://forum.onefinitycnc.com/u/349iq2345)\ **Post date:** [September 14, 2023, 1:06pm UTC](https://forum.onefinitycnc.com/t/sagging-drag-chains/22230/27 "2023-09-14T13:06:06Z")
Hey Michael, hey all, on the [etsy item page](https://www.etsy.com/de-en/listing/1395447873/onefinity-journeyman-or-woodworker-x50?click_key=59b9ee7e491741096cd4c620de57753116bced01%3A1395447873&click_sum=952ec5fa&ref=shop_home_active_10&crt=1&variation0=3366553535), it says it creates a track of 2 inches (50.8 mm) width at the inside, but there is only a drag chain of 40 mm width included (17 x 40 mm). I assume that a 50 mm wide drag chain would also fit, is that right? 2 inches / 50 mm is much more than the much too small Onefinity drag chain (see [drag chain width calculation](https://forum.onefinitycnc.com/t/journeyman-x-50-drag-chain-addition/17984/2) for your individual needs). Thanks for providing the link! --- _[View the full topic](https://forum.onefinitycnc.com/t/sagging-drag-chains/22230)._