# Shutdown kernel panic (this is normal in Firmware 1.0.9 and below, removed in 1.1 and above)

**URL:** <https://forum.onefinitycnc.com/t/shutdown-kernel-panic-this-is-normal-in-firmware-1-0-9-and-below-removed-in-1-1-and-above/10980>\
**Category:** Original/PRO Series (Buildbotics) (Gen 1)\
**Created:** [February 6, 2022, 9:28pm UTC](https://forum.onefinitycnc.com/t/shutdown-kernel-panic-this-is-normal-in-firmware-1-0-9-and-below-removed-in-1-1-and-above/10980 "2022-02-06T21:28:07Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![OnefinityCNC](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.onefinitycnc.com/onefinitycnc/32/7_2.png) [@OnefinityCNC](https://forum.onefinitycnc.com/u/OnefinityCNC)\
**Post date:** [February 7, 2022, 3:06am UTC](https://forum.onefinitycnc.com/t/shutdown-kernel-panic-this-is-normal-in-firmware-1-0-9-and-below-removed-in-1-1-and-above/10980/2 "2022-02-07T03:06:34Z")

</div>

This is normal as of 1.0.9. Just flip the power switch when it gets to this point.

---

_[View the full topic](https://forum.onefinitycnc.com/t/shutdown-kernel-panic-this-is-normal-in-firmware-1-0-9-and-below-removed-in-1-1-and-above/10980)._